Page 1 of 1

Arpeggiator Question

PostPosted: Fri Oct 05, 2012 5:18 pm
by 58smitty
Hello to all from Canada,
I just picked up a used Gaia, and I absolutely love it. To make it even better, Grauw’s Gaia tool is the icing on the cake. Thanks very much to Grauw, you are one special guy! Anyway I have a newbie question about the tool... where can I learn to program the arpeggiator in the tool? I understand the steps but I can’t get it to trigger any notes I enter in the note column. I have watched the midi messages on some of the Fisher patches and I see the different notes triggering. However, when I change them in the Gaia tool and then “copy to temporary patch”, only the note I press will sound. Forgive me if this confusing, after all I am a guitar player, but any help would be greatly appreciated. Thanks


Re: Arpeggiator Question

PostPosted: Fri Oct 05, 2012 6:57 pm
by Mog
Under the arpeggio tab, check that the Motif has Phrase selected.

Re: Arpeggiator Question

PostPosted: Sat Oct 06, 2012 2:00 pm
by 58smitty
Thanks, that worked!